CarPro CQuartz DLUX Wheel and Trim Ceramic Coating ProSize
Treat alloy wheels, faded plastic, and rubber trim with CQuartz DLUX to restore their rich, glossy finish, and give them the lasting hydrophobic nanotechnology protection these surfaces deserve. Applications like this withstand a lot of abuse so CQuartz DLUX was given a thicker film build than conventional CQuartz coatings, and a 50% silica content by volume. When applied to plastic and rubber trim, CQuartz DLUX helps to restore their gloss and color, and protect them from future fading. On painted, polished, or chromed wheels, CQuartz DLUX resists brake dust and road grime, eliminating the need for dedicated cleaners. Protects treated surfaces for up to 1-year between applications.
(1) CQUARTZ DLUX 100ml.
Withstands temperatures of over 800F
Very simple to apply on textured plastics
Excellent UV protection on all exterior substrates.
Versatility: Plastics, Wheels, and rubber surfaces
Average use for 4 wheels and all plastic trim = 10ml.
Headlights, Fog lights, & Tail lights
Plastic Wheel Wells
Make sure the surface is cool and dry. (Do not apply to hot surfaces or in direct sun.)
Scrub surface with an all purpose cleaner and microfiber towel
Rinse while agitating with microfiber towel to remove all residue from APC
Dry or allow to dry completely.
Wipe surface with Carpro Eraser, remove eraser, and allow plastic to evaporate 10-20 minutes before applying
When applying it is VERY important to work one area in even as you go.
Wet the applicator wrapped block with a strip of DLUX and spread evenly across a small area at a time.
Start in one corner and work out! / Don't take on a huge area at once.
Apply nice and even as you go. Dont try to spread too thin but be sure to work it to an even coat in the 30 seconds +/- before moving to the next overlapping area. After a minute you should not be going back over an area that was already applied.
On Textured trim dont wipe it off, just be sure you apply evenly as mentioned.
* On smooth plastic you gently wipe it to an even coat before it becomes too sticky. This results in a thinner coat that doesn’t last as long but on smooth plastic there is not an easy way to apply it evenly.
Directions for Paint and Chrome:
Decontaminate with Iron X
Polish surface as needed
Wipedown with CarPro Eraser
On rims (metal, chrome, clear coat, etc) let cure 1 minute at 85 degrees F up to 10 minutes at 50 degrees F and use a suede MF to wipe it off gently, in a circle motion until no marks are left
Allow to cure 3 hours without water being introduced to surface. If wet during first 24 hours, be sure to wipe off water before it dries on surface.
No washing for 3 days minimum
Avoid contact with skin and eyes
Wear appropriate PPE
Keep out of reach of children
Keep away from heat
Do not ingest
We Also Recommend